How does laser cutting machine technology deal with burr problems? Some customers use laser cutting machines to process sheet metal, and the cutting effect of the workpiece is very unsatisfactory, with a lot of burrs. Then many customers begin to doubt the quality of laser cutting machine products, but it is not the case. During the cutting process of a metal laser cutting machine, due to improper operation and technical issues, the processed material may produce burrs.

Burrs only occur in metal cutting, and there is no burr problem in non-metal cutting. How are burrs generated? In fact, burrs are the excessive residue particles on the surface of metal materials. If a material has burrs, it can be classified as a defective product. The more burrs there are, the lower the quality will naturally be.

The working principle of laser cutting machine and technical analysis have identified the reasons and solutions for the generation of burrs.

1、 There is a deviation in the vertical position of the focal point of the beam. Solution: Adjust the position of the focus and adjust it according to the offset position it generates.

2、 The output power of the machine is insufficient. Solution: Check if the laser cutting machine is working properly. If it is abnormal, it needs to be repaired and maintained in a timely manner. If it is normal, check if the output value is correct.

3、 The wire cutting speed of the cutting machine is too slow. Solution: Adjust and increase the wire cutting speed in a timely manner.

4、 The purity of the auxiliary gas for the cutting machine is insufficient. Solution: Explain how to improve the purity of the auxiliary gas.

5、 The point of the laser beam of the cutting machine has shifted. Solution: Debug the focus and make timely adjustments

6、 Instability caused by prolonged operation of laser cutting machines. Solution: Shut down the machine, restart it, and let it rest.